Sittin_duk

Ok, I just bought the CP Roller Trigger and it's doing some funky things. If I put the gun on ramping and a few shots to where the ramping kicks in and release the trigger, it just keeps on shooting at 17bps for a little bit, and then stops after a while of shooting without me pulling the trigger. Anyone have any ideas?

__________________

bobide

it's called bounce. Raise the debounce on the gun.

__________________
05 PROMASTER , 14" Macdev Matchstick, Kila Drive, Zentriam Valve, ICDU ram, CCM no-rise, Sonic lpr

Sittin_duk

I've never heard of that...how do you change the debounce?

__________________

onesikpup

there is no such thing as debounce on an ion (unless you have something ive never seen before)

this is most likely a trigger problem. either its set too light or your magnets are too strong or weak.

__________________
FEEDBACK

Gangsta_Redneck

take the magnet under the finger guard and screw it out until you dont have that problem anymore (i had the same problem)

__________________

Pm6 werd..

onesikpup

^^^that'll usually work. i had to practically remove mine

__________________
FEEDBACK

Sittin_duk

Do you have to take the trigger out to take the magnet out?

__________________

onesikpup

dont think so

__________________
FEEDBACK