the_quangsta

i just bought it yesterday and putting on the hopper has been a total mystery to me. so far i have unscrewed both screws that tightened the thing where the hopper goes to. with the both screws unscrewed the hopper cant fit in the hole. can someone give me step by step on how to put on my hopper.

TheAznInvazn

What hopper are you using?

All you have to do it loosen the top screw, keep the bottom screw tight; it's what keeps the feedneck attached to the gun
Try wiggling the hopper in he feedneck back and forth, spreading the top of the feedneck apart a little

__________________

the_quangsta

it is a Fasta E-Loader LED Schematics. also when i take out the top screw the top part is still stuck together.

TheAznInvazn

Try opening the top of the feedneck up gently

Don't use too much force, as you don't want to break it

__________________

the_quangsta

dude the top part of the feedneck is like glued together. i tried seeing if there was some type of glue holding it together but no it opens (barely) if i use a tool like a screwdriver. but with my hand is of no avail.

TheAznInvazn

Try sticking a dowel in there or something and gently pry it apart

__________________

Crawdaddy

Lightly sand the feedneck of the hopper until it fits.

Trbo323

bingo^^^

a lot of times hopper necks are a little large to start with

does your feedneck tighten down when you turn that screw in?

__________________

blue to black dm6
hyper 3
top hat mod
laser eyes
CP flow plug
32 degrees drop forward (yes i like my drop forwards)
cp micro on/off asa
deadly winds 14" fibur barrel with full freak
Dye rotor with speed feed
centerflag 68/4500 with on/off