D FO

i finnally got an impulse now i took the bolt out which is the otb blind bolt and i cant see to get the bolt pin to stay in good? if i turn it upside does and barly shake it then it will come out is it supposed to do this? also the barrel i lubed the o-ring because it would go all the way in is the o-ring supposed to be all the way inside the gun? its stickin out a little bit

__________________
-Dan

Peanuth8222

your bolt pin is probably falling out because its not fully connected to your hammer. and on my impulse a little part of the o-ring does stick out on ur barrel, it doesnt go into the gun all the way or else it would be too hard to screw out.

D FO

theres no more room for the bolt pin to go though?

__________________
-Dan

Huey69

Have the hammer forward, look to see where the hole for the hammer is. Insert bolt into proper tube, and look for the hammer hole through the bolt pin hole. Make sure the bolt doesnt move, and get bolt pin and put through. Hope i helped.

__________________
Taking a break....teamless for now

D FO

its in the hammer but its still pretty loose? its a sp brass hammer and stock pin with otb bolt. my friends with imps didnt have this problem ill take it up to the proshop sometime and see what they say

__________________
-Dan

hchammer

check to make sure that your bolt pin will go into the hamer grove tightly w/out the bolt. Then try to put the pin trhough the bolt and see if it grabs........usually this kind of stuff is pretty easy.

__________________

• DM4
• Aluminum Freak Back w/ stainless steel inserts
• WAS chip
• HALO w/ Victory board
• 88cu in 4500 Carbon Fiber Crossfire

D FO

it wont go into the hammer titly is the thing and when i turn the gun upside down with or without the bolt the boltpin falls out i asked one of my friends with an impy and he cant tell me anything

__________________
-Dan

bunkertime

It's the ball bearing in ur Bolt

Take the bolt outta the gun and look at the back part of it. there should be a hole in the back. Take an allen wrench (i don;t know wut size OTB uses, so just use one ti'll u get a good fit) and Screw the small allen screw inside the bolt In more. this will increase the preasure of ur ball bearing in the bolt and hold ur pin better



As for the o-ring on the barrel.. All it does is hold the barrela little tighter to the body, It's not nessisary to have it there, but if it's there, just leave it. And there is no need to lube it, just screw it in until it's snug with the body, don't risk stripping those threads.

__________________
she's a virgin if u don't count anal


•••

D FO

omg!!!!! bunkertime i love you your a genius a pur genius thank you so mucth i was so mad when i got it like this you helped me so much. your the impulse god !

__________________
-Dan