Thread Tools

**Peanuth8222** · October 8th, 07:18 PM

ok today i installed my Ndz High Flow vavle and i turned my on/off on and i had a very small leak down my barrel. i could hear it but i could barely feel it. whenever i turned my max flow up it would start to get louder and stronger. so does this mean i have to clean my max flow or wut? i cant take it to a sop tomorrow casue i got a practice tomorrow.

**paintbug** · October 8th, 09:22 PM

did you leave the main spring out? you were supposed to. i have seen it where the valve would get caught on it. rare but it happens.
did you put the valve in from the rear? if not you may have cut the orings on the valve.

**Peanuth8222** · October 8th, 09:31 PM

yes i put the vavle in through the rear.

**bunkertime** · October 8th, 09:35 PM

hmm.... might not be seating right, make sure u only put ur Maxxy to a maxximum of 150 PSI w/ the Rip valve, also, inspect the valve itself, sounds like u chipped an o-ring, even putting it in through the back, or it aint' seating.

***xPiZZeRx*** · October 8th, 09:44 PM

Aren't you supposed to grease an o-ring somewhere on the valve?

And is the valve poppet or whatever, the plastic type thing inside of it, is that delrin?

And if you do need to grease one of the o-rings tell me which one. I think it's the one on the poppet though, not sure.

**Peanuth8222** · October 9th, 12:24 PM

ok i dont know why i'm having these problems with my impulse but i am. ok today i was trying to walk my trigger and my bolt wasnt moving fast enough so i decided to turn the dwell dwon a bit and also when i was shooting it was making a really bad hissing sound. ok so i lowered the dwell and i still couldn't shoot fast so i lowered it more. i took out my hammer and there was a tore o ring. i replaced that but it was still making a hissing sound and i culdnt get up to speed.

later on my bolt just completely stuck foward and i was having a small leak out of my solenoid housing.

Edit: nvm i fixed it

Thread Tools

View more Paintball photos