Thread Tools

**impulse_owner24** · December 28th, 01:52 PM

i have an impulse and when i srew int the compressed air in shoots out of the regulator (max flo reg.) and i dont kno how to fix it... any ideas???

**MuddinPede_98C** · December 28th, 02:34 PM

You have probably set your input pressure too high, over 220 psi, and caused he PRV(Pressure Release valve) to open. This may have also shocked your solenoid, which shortens it's life time. No worries, it should still work, though. Try lowering your pressure very low to reset the PRV, then keep it set at 180.

**Roadkill** · December 28th, 02:55 PM

try unscrewing the knob on the botttom of your reg until right before it comes off, then gas it up. This will take out just about all the input pressure into your marker. When the tank is screwed on slowly screw the knob back in. This is how to adjust the input pressure.

***Barber*** · December 28th, 04:50 PM

Put your Max-flo at 170 and adjust your dwell from there.

**paintbug** · December 28th, 07:50 PM

if its blowing out the bottom of your reg, then you will need to replace oring #50. its the first one from the top of the vert reg.

**impulse_owner24** · January 5th, 07:16 PM

just to let yal kno i got it working it was the o-ring.... thanx paintbug

**paintbug** · January 5th, 10:14 PM

no problem!

**bunkertime** · January 6th, 08:22 PM

Score 1 for Paint bug! W00t!

**paintbug** · January 6th, 08:33 PM

Thread Tools

View more Paintball photos