nelspot007

Guys I need some help with my tippmann.

I took it apart to clean it because the previous owner did not take care of it (it worked good before that) and now after I cock it manually and pull the trigger it won't recock itself some time if i hold the trigger it's like an automatic and chops the hell out of balls. It like the sear isn't catching or the bolt doesn't come back far enough. HELP

Nor*Tex

try pushing the sear in more mine slipped off the sear pin some times uhhhhhhh the sear mite be worn down depending on hoiw old it is to where it isnt cathing

just thought of this, check the sear spring it mite be so worn that there isnt enough tension 2 move the sear back

hope this helkps and welcome 2 the forums!

__________________

OSU

Torch

For the not recocking itself part, look and make sure the detent isn't in backwards. If it is it'll catch the front bolt and will stop the gun from cycling.

As for the full-auto paint blender problem, look over the sear and the rear bolt. Make sure they're both square and not rounded off.

__________________
"RD&D - Research, Development, and Design. - If its not broken, fix it anyway."
T.O.G. #131 - P.O.G. #16 - C.O.G. #145 - Tippmann Forum Moderator
Rate the: 98C SL-68-II Feedback
Other members flaming your posts? Help is available
PBF boys still play with Trucks. Check out www.trukz.com

nelspot007

thanks for the input guys .. my sear and spring look to be in good condition i will replace my rear o ring and check the detent

thanks

tippmann98777

hey if it is your sear spring try the ruber band mod in the mod secton that works pritty good exept u might breack a ballevryonce in a while but with nething u will brak balls one in a while

nelspot007

rear oring was bad, don't know if i had the ball latch backwards or not i do remember but i will now look at it everytime i take it apart...i put about 100 shots through it seems to be ok now

thanks guys