Igotshot

I was reading that you have to cut some of the grip to get the tippmann double trigger guard to mount right. Is this true? If that is true is it hard to cut?

dhill0413

with the original tippman 98 you do have to cut it....with the 98 custom you dont, unless your getting some weird double trigger

__________________
2k2 LCD C&C
Cocker Owner #21....Green 2k2
Model 98

Igotshot

thanks alot

b_heald

you have to cut some on the 98c it depends on what type of trigger you get
him me up on AIM at CWRUbro if you wanna know more

__________________
AIM is CWRUbro

pigstick

There are two different types of double trigger. One that is straight L shape, and goes into the lower trigger guard hole, and one that goes into the original single trigger hole.
The L shaped one requires you to cut a little out of the grip part.(rubber part not the handle)

__________________
wooop

Igotshot

could someone link me to the one where u dont have to cut out some of the grip

big_balla

If you take the grips off, you can see where Tippmann made a slot for the 2x trigger guard. All you need to do is make a little notch on each grip. You can do this by taking one of the grips off. Then by taking a little chunk, of the grip still on there, off where the notch is for the trigger guard. You can do the same for the other grip. This might seem comfusing, but you can pm/aim me for more details/a better explanation. Hope this helps.

Mike

__________________