Started life as a 99 Rainmaker serial # 7131
-2k2 intimidator frame with Check It Products sweet-spot stick trigger
-mad marty mods 1-5
-polished internals
-aka tornado valve
-white derlin bolt
-TLACO chipped 99 board
-upper receiver milled for angel ball dent
-rainman229 volume chamber backblock
-rainman229 mac mount frame adaptor with frontblock and cocker asa
-clipards ram
-highflow hose kit
-smart parts rail and on/off asa
-palmers stabilizer with bike grip
-palmers micro rock with knob
-32 degrees gauge
-dye sticky grips with led set in it
-alien invasion barrel
the timmy frame was dremeled so that a 9 volt battery could fit where the lcd use to be and also so the TLACO could fit inside the grip. I dremled out the rear screw hole so that the screw fit inside the body.
the only stock/unmodded parts left are the bolt link, feed neck, bolt cover and lower recevier.
im not going to say its sexy or looks amazing, frankly it looks like a frankienstine creation, but it also looks like it will open up with 35 bps of paint slinging fury, and given that it is the most custom marker iv ever seen
congrats you are getting the first 10 i have ever given out
My buddy had one of these in pieces. This was like 4 years ago I never did figure out how to put it back together. Probably would have just broken it worse if I had.
10/10 for sure. Get a sick anno and some laser engraving ot make it even more unique.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Paintball Guns and Gear forums
1.4M posts
64.8K members
Since 2001
A forum community dedicated to Competitive Paintball players and enthusiasts. Come join the discussion about paintball markers, goggles, masks, air, stores, and more!