Paintball Guns and Gear forums banner

Valve Spring Trouble

431 views 2 replies 2 participants last post by  Ahmadi6490 
#1 ·
I recently bought a 32 degrees turbo valve and I installed it but later into my game air was leaking out of my barrel, so tonight I bought a really hard valve spring that the guy recommended at the proshop. When I was taking the upper part of my expansion chamber apart 2 big o-rings flew out and they were a bit damaged, where did these go? Then I installed the new spring and aired it up, all it did was leak heavily. Where do these o-rings go and where can I get them? Also my expansion chamber still feels a bit cold now and it's been about 30 mins, I think some airs still trapped in there, not too sure.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top