im about to install a new valve, (new designz) how do you take it out and put it in? you dont need a valve tool for spyders do you? ill prolly just try poking it out with a pen or something if nobody responds by the time it gets here thanks bye
you knock out the little pin on the side of the body. Take off the front asa/block thing, remove contents, and slide it out. Thats how i do it anyways.
**-edit, you must remove your trigger frame, look at the bottom of the body, unscrew the screw underneath, then it will come out.
that covers it prettywell...not sure about your gun(didn't notice what kind it is) but on some spyders you have to also remove a screw that is under the tigger frame. correct me if i'm wrong guys.
yah, the pin can stay where it is, just take out the vertical adapter, and the set screw, then push it out. Just make sure to use something soft like a pencil eraser so you dont screw it up.
Just the brass screw needs to be removed.Glad you got it I have read threads where people ruined the body try to remove the valves.Post on how it works I have a taso valve but may be willing to upgrade down the road,LOL. =0
I just push the valve out with my cheap brass eagle squeege.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Paintball Guns and Gear forums
1.4M posts
64.8K members
Since 2001
A forum community dedicated to Competitive Paintball players and enthusiasts. Come join the discussion about paintball markers, goggles, masks, air, stores, and more!