Paintball Guns and Gear forums banner

1 - 5 of 5 Posts

·
Taking Back Control
Joined
·
2,191 Posts
Discussion Starter #1
Sometimes, i want to lay down a decent amount of paint so ill start shooting as fast as i can pull my finger and sometimes the gun wont cock all the way back. It comes about 3 mm from being cocked. any suggestions?
 

·
3D Airsmith
Joined
·
1,689 Posts
If you areusing co2 the pressure is droping off cause the co2 is not turning into gas in the tank fast enough cause the tank cools off a little each time you fire. so eventualy the tank cools of enough that the liquid co2 can't turn into a gas fast enough to maintain the pressure needed to operat the gun fully and there is no real trick to advoit this. and expantion camber just gives you an extra volume of gas to work with but if the tank is too cold then it can't do much to help.

But if you gun is what is in your sig i would recomend polising the internals of your gun because it will reduce the force need to blow the hamer back and help improve the preformance of the gun if done right. A guide can be found here

Also takeing the gun apart and cleaning it every so oftenwill help out
 

·
Registered
Joined
·
3,172 Posts
Mine used to do that before I switched to HPA. Come to think of it, everything got better after switching to HPA...the flowers seemed brighter and birds singing was more beautiful all because I switched to HPA....best damn thing to come along since the Hansen triple homicide...oh damn there I go dreaming again.
 

·
Registered
Joined
·
33 Posts
Smitty said:
Come to think of it, everything got better after switching to HPA...the flowers seemed brighter and birds singing was more beautiful all because I switched to HPA....best damn thing to come along since the Hansen triple homicide...oh damn there I go dreaming again.
Lol Smitty. If that's true mabey I'll go HPA too.

I was going to give you a completely different solution but what Mortis said sound's alot more intelligent then what I'de say lol.
 
1 - 5 of 5 Posts
Top