Paintball Guns and Gear forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
there is air being released through the barrel of my impulse, i checked the valve assembly, bolt, solenoid, and hammer. all the o-rings are fine and there is nothing i can see that could cause this leak. it started from the solenoid, and after i fixed that i shot a half hopper of paint balls and then it started to leaker rapidly through the barrel. any suggestion?
 

·
Premium Member
Joined
·
23,657 Posts
sounds like a cupseal or valve leak. reset the cupseal int eh LPr and inspect the o-rings of the valve. It could also be the valve pin not sealing against the valve as well.
 

·
Registered
Joined
·
7 Posts
Discussion Starter #3
alright i fixed the leak that was coming through the barrel by lubing and replacing all o-rings, but now there is a leak in my solenoid. ive checked all the little o-rings on the spool,lubed it up, made sure i put the spring and gasket back in the right way, the gasket is in mint condition, but when i gas it up air keeps leaking ive tried everything. any help?
 

·
Registered
Joined
·
6,346 Posts
Solenoid/gasket could be bad.
 
1 - 6 of 6 Posts
Top