Paintball Guns and Gear forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
I am looking into the ANS vertical feed that screws right into the gun. It has two orings inside to hold the hopper in place. Has anyone used it, how does it work?

More importantly I am looking into etriggers for my Xtra. Is there one that you guys reconmend. I plan to get the upgraded system with the eyes. but that is down the road. For now what should I get that will allow me to upgrade later.

For the new trigger with the eye's it is just a circuit board not the whole frame correct.

thanks guys.
 

·
Registered
Joined
·
717 Posts
The feed neck should work fine and if its too tight you can sand down the hoppers tube. And by E-trigger do you mean a whole new frame? If so look into an aluminum frame such as the 3.0 IPI or a frame off an Imagine or Esprit. And look for info on the T-board, IS board, and XSF advantage kit in which all can reach up to about 22bps and have eyes.
 
1 - 3 of 3 Posts
Top