Paintball Guns and Gear forums banner

1 - 10 of 10 Posts

·
Registered
Joined
·
2,798 Posts
Discussion Starter #1
I was paintballing earlier today and everything was fine. Just later on today when i was lubing my valve my putting oil in the air asa I coked it and aired it up, shot once and all it did was burp. The striker o-rings fine but it may be my sear, it's going to the proshop tomorrow but maybe I can fix it before, whatcha think?
 

·
Retired
Joined
·
4,332 Posts
these are other things that can/might cause it:

liquid co2 getting into the gun sporadically
bad hammer o ring
worn valve spring or velocity spring
too much oil (on hammer/sear)
worn sear
worn hammer
bad sear spring
dry valve o rings
 

·
Registered
Joined
·
2,798 Posts
Discussion Starter #10
My gun came back from the shop and they said my cup seal wasen't on well so air was leaking through. I tested it out and it was fine for about 15 shots, then it started burping again. I'll take it back with my recipe cuz I had to pay $15 for them to fix it.
 
1 - 10 of 10 Posts
Top