Paintball Guns and Gear forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
591 Posts
Discussion Starter #1 (Edited)
Dragun "The One" Trigger Frame

its here X Paintball.


it says the kit includes

Front block.
Low pressure regulator.
Front Dragun regulator.
Grip frame.
Drop forward.
Ram assembly

what are those and what do they do?
Would I want an Expansion Chamber if I was gonna get this?
The thing in the top left corner where does that go?
 

·
Registered
Joined
·
1,996 Posts
That kit turns your gun into an electro-pneumatic much like the bushmasters. It is a great upgrade and will make your spyder perform very nice. And no on the ex chamber, the one kit has a reg that goes where the ex chamber would and ex chambers are useless anyways.
 

·
Registered
Joined
·
591 Posts
Discussion Starter #3
sick_dawg5440 said:
And no on the ex chamber, the one kit has a reg that goes where the ex chamber would and ex chambers are useless anyways.
so there is another kit thats similar but has one thing in it thats different?
whats an ex chamber do?
electro-pneumatic?
 

·
Registered
Joined
·
591 Posts
Discussion Starter #5
ok now the link I put at the top what are the two small things in the middle?
where do they go?
 

·
Registered
Joined
·
208 Posts
It's pretty simple. Take out the stock internals, replace them with included ram and valve. Replace stock trigger frame and ASA with the "One" frame and ASA, connect all hoses, and you're pretty much done. SHouldn't take more than a half hour.
 

·
Registered
Joined
·
1,996 Posts
Yah, it is basically removing the old parts and sliding the new ones in. The electro pneumatic uses a pneumatic ram in it to power the gun, and is a little more efficient than the blowback where the striker is pushed forward and blown back.
 
1 - 11 of 11 Posts
Top