Paintball Guns and Gear forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Programming seems straight-forward, however it is not giving me the option to program the Feed Stack Monitoring (red light).

When I go through the programming phase, I can program the motor speed (green), then microphone sensitivity (orange), with no problems. Then it should go red according to the instructions so you could program the feed monitoring, but it doesn't even give me the option to program the feed monitoring and ends up turning off as if the programming is over.

Batteries are brand new. Even tried replacing them for sh*ts and giggles and same problem. Is there something I'm missing or is it defective?
 
1 - 2 of 2 Posts
Top