Paintball Guns and Gear forums banner

1 - 5 of 5 Posts

·
mil-simer
Joined
·
1,102 Posts
Discussion Starter #1
I actually have a BT TM-Series Rip Clip on my TM-15, and I am disliking it. Is jams way to much and some times it forgets to feed even in the highest velocity. Si I was thinking on getting a new loader. I like the Q-Loader and the Prophecy Z2, but I need and opinion:

The Prophecy Z2 can hold up to 200 rounds, but it has a bigger profile than my Rip Clip. Plus, it won't let me use mi sights (I am planning to put it a red dot if the APEX2 works like I expect). The Q-Lader hold only half of the ammo. But I really do not care much about it. I am ok with 100 rounds.

Before deciding I will like to know a few things:

1. ¿How big it the q-loader pod? To see if it will fit my harness, I currently use 150 round proto pods so if they are more less the same size it's ok.

2. ¿Is there something I can do to put the prophecy off-set so that i can use a red dot?

3. Please give your opinion so see what I should do.
 

·
mil-simer
Joined
·
1,102 Posts
Discussion Starter #3
Personally i hate the q-loader.

a q-pod is about the same size as the proto pods.

the tm15 feedneck is offset as it is isn't it? so what's the problem with the red dot?
The problem is that if I use an APEX2 barrel and a red dot I have no guarante that the red dot will point directly where the APEX2 es pointing at, so I will have to get a weaver. Without the weaver any loader does just fine, but with it, the hopper will block my line of sight.

PS. Why do you hate the Q-loader? It will be good to know.
 

·
mil-simer
Joined
·
1,102 Posts
Discussion Starter #5
i play speedball ^.^

i've just never gotten used to the balance of a q-loader marker. and i don't wanna deal with filling them
That's ok. Well, I decided I prefer the Prophecy Z2, because the Q-loader is way to expensive in the end of what it is. But I may change my mind in the end.
I will decide when I try the APEX2.
 
1 - 5 of 5 Posts
Top