Paintball Guns and Gear forums banner

1 - 3 of 3 Posts

·
6969696969
Joined
·
394 Posts
Discussion Starter #1
I recently just bought an etek ego from my uncle for 300 dallars. I have a tank, and I was wondering what else do I need to do before firing it. Do I need to set anything before I turn it on and screw the tank in. I have read the manuel threw but it not really helping much.
I would ask my uncle but he got it from a friend of his and never used it.
-Thanks
 

·
Registered
Joined
·
5,080 Posts
Is your tank a HPA tank or CO2 tank? You can't run CO2 on ETeks.

Assuming the HPR and LPR haven't been messed with and are working properly, then you can go ahead and try firing it. I'd check the set screws on the LPR and HPR to make sure they are set reasonably. The LPR set screw I believe should be flush with the front cap, the HPR I'm not sure. Just to be safe, you might want to set the HPR very low (turn it very far out/in, whatever the manual says to decrease pressure), gas it up, and slowly increase it until it shoots normally.

PS: This belongs in the Eclipse section (http://www.paintballforum.com/eclipse/), not in general chat.
 
1 - 3 of 3 Posts
Top