Paintball Guns and Gear forums banner

1 - 7 of 7 Posts

·
bow chicka
Joined
·
2,640 Posts
Discussion Starter #1 (Edited)
Aliens website

Alien comparison chart

ALIENS ARE COCKER THREADED!!!

Interceptor PDF manual


Remains PDF manual


Q: What operating design is the Alien Interceptor?
A: Its an electro-pneumatic pin valve

Q: What kind of board is in the Alien?
A: A WAS equalizer board. It has Semi, PSP and NXL ramping. The board can have a LCD put on it but does not come with one.

Q: Is the Alien hard to maintain?
A: Not really, There are only 3 main pieces (ram assembly and housing, and then the trigger frame).

Q: How fast is the gun?
A: Its as fast as your hopper.

Q: Is the Alien heavy?
A: Its not the lightest but still really light. Its under 2 lbs with out a barrel, reg.

Q: What is the operating pressure for the LPR?
A: Interceptor: 70. Alien: 85-125

Q: What am i going to get off of air efficiency?
A: Its very good, considering the design of the gun.

Q: What should i use for lube?
A: Use a lighter oil, not lube. The bolt is delrin so it shouldn't need to be lubricated.

Q: What barrel threads is it?
A: Cocker threads

Q: What feedneck threads is it?
A: Ion/impulse

Q: HPA or LPA?
A: HPA is recommended, but LPA is usable. Shoot down may occur with an LP tank.

Q: What type of boards does it accept?
A: NME or Alien boards.

Q: Where can i find stuff on this alien gun called, "The revolution?"
A: Its the old name for Alien. If you hear alien thats the revolution.

Q: I want/need a new LPR. What kind can i get?
A: The older intimidator LPRs should fit.
 

·
bow chicka
Joined
·
2,640 Posts
Discussion Starter #2 (Edited)
How to set up your alien for play

Step 1: Turn the LPR up a little high. Interceptors: about 85 psi, Aliens about 125.

Step 2: Turn the HPR so its shoots about 5-10 fps above 300 (or what ever speed you need it to be at)

Step 3: Turn the LPR down until its under the fields FPS limit.

Step 4: Go "gat gat gat" and pwn newbs.
 

·
bow chicka
Joined
·
2,640 Posts
Discussion Starter #3 (Edited)
I, nor any one else on this forum, is responsible for you wrecking your gun if you take the advice given here or any where. YOU took it on your own will.

Also this would be a good place to make comments or small questions. If any thing is wrong in here let me know.
 

·
Registered
Joined
·
1 Posts
If you want to paly Alien you should follow this instruction.

Step 1: Turn the LPR up a little high. Interceptors: about 85 psi, Aliens about 125.

Step 2: Turn the HPR so its shoots about 5-10 fps above 300 (or what ever speed you need it to be at)

Step 3: Turn the LPR down until its under the fields FPS limit.

Step 4: Go "gat gat gat" and pwn newbs.






Lexus SC430 Parts
 
1 - 7 of 7 Posts
Top