Paintball Guns and Gear forums banner

1 - 6 of 6 Posts

·
Bringer of large farts
Joined
·
2,370 Posts
Discussion Starter #1
What voltage is a halo running at for the best results(ie faster load rate). I have some smaller 1400 mah and 1100 nah li-po packs that i would like to use, as i have a quick field charger for them, and im thinking of converting my imp to rechargeable pack as well versus the 9v.
 

·
Bringer of large farts
Joined
·
2,370 Posts
Discussion Starter #3
MAH are only capacity, im curious about voltage and amperage needs.
 

·
Registered
Joined
·
568 Posts
Just take what it's running on right now and figure voltage. Put a volt meter across a unused alkaline of the flavor you're using and multiply by the number of bats. As you use bats the voltage drops. Now the Halo might be able to handle more voltage? Don't know if you get specs with it. Usually rechargeables will have a lower voltage per cell than alkalines.
 

·
Bringer of large farts
Joined
·
2,370 Posts
Discussion Starter #6
thanks that tells me what i need to know. I may run the 11v li-po batts i have with it eventualy. They last much better, and do not have voltage the droop problems as they drain.
 
1 - 6 of 6 Posts
Top