Paintball Guns and Gear forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
132 Posts
Discussion Starter #1
i was lubing my gun , put it back together and cocked it and pulled the trigger but wen i pulled the trigger it wudnt shoot and then i found a black 6 sided nut and didnt know where it belonged. what do i do?
 

·
Registered
Joined
·
119 Posts
mistakes i've made with my x7: forgot to put guide pin in driver spring. i think there's only 2 nuts like that and one is in the cyclone. the other i think is just under the trigger assembly bottom right if the gun is facing left
 

·
Registered
Joined
·
119 Posts
trigger might not be aligned properly. look at that first since it's easy to take off. i dont think the gun will cock with the hammer upside down but you can check. the notch should be on the bottom.
 

·
Registered
Joined
·
132 Posts
Discussion Starter #7
ok i solved it u were right becus i have a 3 point adjustable fang trigger for it and i went a lil phsyco with the adjusting thanks dude but i stil dont know were the heck the nut goes
 
1 - 7 of 7 Posts
Top