Paintball Guns and Gear forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
920 Posts
Discussion Starter #1 (Edited)
Ok, I have a Kingman Hammer, circa 1992(i think). I have a couple little annoyances with it. 1. The velocity is VERY low. I think that it is about 200. I do not know how to change it. 2. Does anyone know where I can pick up an adapter so that I can use regular size c02 tanks, because all it can take now are the 12 grams. :?

EDIT: I found some traccer/maverick stuff. would this fit my gun? I found a bolt, and it looks exactly the same as the bolt in my gun. I am nearly positive that the Maverick/Traccer are clones of the hammer. DO you think that these would fit? I also found a CA adapter. The only difference is mine has a long metal tube in my 12 gram adapter, that goes into my gun. This one has a short tube. Does anyone know if these will work? Thanks.

Please help. Thanks. wave:
 

·
Registered
Joined
·
11 Posts
help

Ok, I have a Kingman Hammer, circa 1992(i think). I have a couple little annoyances with it. 1. The velocity is VERY low. I think that it is about 200. I do not know how to change it. 2. Does anyone know where I can pick up an adapter so that I can use regular size c02 tanks, because all it can take now are the 12 grams.

-There are two ways to chance Velocity. A) You have one of those tuning bolt inside. You can see it if you screw of the barrel. If yes you can take a screwdriver and screw it till you have the velocity you want(about +/- 60)
If not you just see a hole in the bolt.B) Than you have to buy a Tuning Spring that you change with the spring inside. Take of the Grip frame, with the two Screws ,one behind and one in front of the Gripframe. than take the internals out.(Remember how it was to get it in right again) Change the Spring now , get all in , Gripframe on ,ready. 300FPS.

-You dont need an Adapter for it, The Quikchange(where the 12 grams are in) has a thread that is screwed in the ASA Adapter(thats how its called) thake it out and the thread you find will fit CO2 tanks. Danger! If you have a Hammer P (plastic) beware of threating the plastic around the Back Gripframe Screw to hard. That happens if the Co2 tank or the Quikchange is screwed in or out to hard. It breaks and then you have a real Problem. Carefully !
Gonzales :yikes
 

·
Registered
Joined
·
920 Posts
Discussion Starter #3
Thank you. I will see if it has the bolt. I do have a hammer p. I hope i dont break the frame. THanks.
 
1 - 3 of 3 Posts
Top