Paintball Guns and Gear forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I just got a check it products 15degree assault block for my victor 2,,,
I put it in and screwed the screw in all it could go (the screw is still sticking out alittle) but its still wobbly like it isnt a tight fit.
can anyone help?
 

·
Superdeeduper Admin Type
Joined
·
17,772 Posts
Hmm.. Is the victor 2 a slim or fatty striker system? If it is the fatty, then the CIP will not fit.

If you put pressure into the marker, does it leak? If not, then live with it, if so, then you have a problem.

I don't think there are bigger o-rings to put on it, but you may be able to take up some of the room if you oil the rings well and let them swell a bit.
 

·
Registered
Joined
·
12 Posts
Discussion Starter #3
i dont know what you mean my slim or fatty...but its not leaking from what i can tell...
its just annoying..thats all
 

·
Registered
Joined
·
12 Posts
Discussion Starter #5
i just checked it out real quick..
i didnt take out the block yet, the screw holding it in is pretty messed up. i dont wanna mess around with it until i get a new screw.
I hooked up the air, theres no noticable leaking, i even put my ear up to it and i heard nothing, and when pressurized, the block wasnt wobbly anymore.

for those of you who do have it, it the screw that holds it in, does that go all the way in on your guns?
 

·
Registered
Joined
·
12 Posts
Discussion Starter #7
does anybody know the size to the screw that goes in there?
mines messed up pretty bad.
would any hardware store carry it?
 
1 - 7 of 7 Posts
Top