Paintball Guns and Gear forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
i need to know how to install the shocktech trigger on the dm4...?

when i go to place in the pin... it gets stuck hlf way & does not go thru completely...

please help...
 

·
Registered
Joined
·
46 Posts
Look at the pin, one end is sometimes flatter or has marks on it, that is the head of the pin. Also the Shocktech trigger is a roller bearing trigger, which means the pin must be tight so the trigger uses the bearings, not just moving on the pin. It takes some force to get these type triggers in. Good luck.
 

·
0ld Sk00l
Joined
·
3,773 Posts
^^ Exactly right

Try using a peice of wood over the pin, then use a hammer (keeps from missing and denting the gun)

The pin will be very tight.. make sure to remove the trigger frame from the gun and remove the electronics from the frame, that was ur not putting ne excess stress on ne thing
 

·
HRD
Joined
·
2,925 Posts
bunkertime said:
^^ Exactly right

Try using a peice of wood over the pin, then use a hammer (keeps from missing and denting the gun)

The pin will be very tight.. make sure to remove the trigger frame from the gun and remove the electronics from the frame, that was ur not putting ne excess stress on ne thing
yeah wouldnt want to beat up the electronics or youll get quite the headache from a simple trigger install. try a rubber mallet too so incase you do slip somehow and hit the gun it wont dent/scratch
 
1 - 4 of 4 Posts
Top