Paintball Guns and Gear forums banner

1 - 9 of 9 Posts

·
Screaming Koala
Joined
·
4,685 Posts
Use a hammer and a punch. If you don't have a punch, you can use any number of things such as a hex key or small nail.

Drive the pin out by hitting it on the smaller side, which should be the side that does not have the * shape. Unless they changed the setup it's right side, looking down the frame as you would hold the grip.
 

·
Screaming Koala
Joined
·
4,685 Posts
If it is jammed with dirt or something, you could try this.

Take two little blocks of wood and set them up so that the pin will fall out between them, but the frame is supported (take it off the gun if you haven't already). Hold the punch or nail in on the pin and then give it a good solid crack. Make sure you have the proper side facing up or you will probably damage it pretty good.

I haven't found a spyder pin that stuck good enough to take much abuse. I bet your either not hitting hard enough or you have the wrong side picked.
 
1 - 9 of 9 Posts
Top