Paintball Guns and Gear forums banner

1 - 7 of 7 Posts

·
Banned
Joined
·
412 Posts
Discussion Starter #1
my gun is leaking from the trigger frame right were the trigger comes out of the frame. i need some help and its not lookin good cause there is like 2 threads right now
 

·
Registered
Joined
·
15 Posts
there arent many threads huh? lol im not an expert on JT guns but my bud has one and he had the same problem all i could think of was replacing the oring on the part that goes above the sear im not sure what its called but the part that the trigger frame trips when u pull the trigger the part im talking about is also attached to the bolt just change the oring on that and it stopped the problem 4 him so i hope it works 4 u to
 

·
Registered
Joined
·
440 Posts
You probably have bad cup seal or bad orings on the vavle.You can check the bolt but I have my doubts.You really want to know.Remove the grip frame take the bolt and striker out.Remove the barrel.Now fill the kitchen sink with water.Gas the gun up some people will say" oh good god no man."Nothing will happen with the bolt out because the striker has to press on the vavle to release air to fire the shot.Now with the bolt out you be able to see the valve.Now submerge the body with the air source under water.You will probably see lttle bubbles comming out of the body of the gun.These bubbles are because gas is escaping past the cup seal most likely.Get your manual out to find out where it is located.could be the o rings on valve but I have doubts about that.DO NOT MONKEY WITH THE VALVE UNLESS YOU HAVE TO.More problems happen when people remove their valves ,because they score the orings and then gas leak by.So do the water thing first ,MAKE SURE TO REMOVE THE GRIP FRAME SO YOU DO NOT FRY THE ELECTRONICS.Then after confirming the leak remove your air source or CO2 .Wipe the whole gun down and dry it even on the inside you may have to use paper towles and a pencil,whatever.Replace the cup seal and put the gun back together putting some oil on the bolt and striker.I keep hearing about the bolt orings but that will not cause a leak that will just knock your velocity down and cause some gas to blow by the orings.Now that is as simple as I can put it to fix the gun.If you do not understand how to do it take it to a PB shop.my orings started leaking on my valve the only way I could figure out exactly what was happing was to dunk the body underwater.Sounds dumb but it works,LOL.Goodluck.
 

·
Banned
Joined
·
412 Posts
Discussion Starter #6
dude jts suck i put my spyder body on it and it worked perfectly fine it was somethin with the body but i got a b2k/pds for christmas it is awsome i recommend icd guns for yall in the jt group the bko's are very nice also.
 
1 - 7 of 7 Posts
Top