Paintball Guns and Gear forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hey all,
I have a phantom stock class (SC) pump that runs on 12 gram C02 cartriges. I have found the parts IN THE GUN that i need to replace to convert it to a bulk tank C02 gun. but i can't find this parts online. anyway, i may just be stupid or blind, so here's the parts i'm looking for,

a breech and a new air adapter for a bulk tank, like i said before.

anyway, remember these parts r for a phantom stock class pump!

if ya know anythin, reply!

()_()Urbankamo()_()
 

·
Registered
Joined
·
2,416 Posts
Well, we can't post any sites besides www.XPaintball.com. Did you try www.Froogle.com?

All you need is to turn your SC into a VSC Phantom, take off the Puncture Pin Assembly with a 3/8 allen wrench. Then you can get a CO2 tank and directly attach it there. If you plan on having the tank horizontal you can put a regulator (not that needed for Phantoms) directly were the Puncture Pin Assembly was, and then like a normal marker just get macroline or stainless steel hose and run it to an ASA. If you don't want to get a regulator you can run it through a gas-through.

-Mike
 

·
Registered
Joined
·
3 Posts
Discussion Starter #4
yeah, um, well, im kinda stupid, so put it in terms a kid with the attention span of a rodent might understand.

()_()Urbankamo()_()
 
1 - 7 of 7 Posts
Top