Paintball Guns and Gear forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I have been trying to track down my leak on my ion and what is causing it... it seems like it is coming out of the rear banjo fitting that is on the doughnut... some people say that this fitting should have 0 pressure going to it until the gun is fired, and that this means my solenoid is bad. Other people say it could be the hose or fitting it self. I just need to know that with air hooked up, and the gun off with no battery should there be any air running to the rear banjo fitting. I would hate to buy a noid or new board when all i needed was a simple o ring or hose! thanks in advanced!
 

·
Registered
Joined
·
12 Posts
Discussion Starter #3
thanks a lot! that means my noid is probably good, i can hear it click when i pull the trigger with the batter on and no air with the board out of the gun
 

·
Registered
Joined
·
12 Posts
Discussion Starter #5
it was the rear banjos hose and the hose coming into the noid as well... i replaced both of them and the gun is leak free! thanks everyone... someone on a diff forum said they thought it was my noid, glad i did more research and did not buy a new one!
 
1 - 7 of 7 Posts
Top