Paintball Guns and Gear forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter #1
I spun the original gauge on my vs2. Then I blew the face off of the dye gauge that I used to replace it. I thought it was all bad luck until today after replacing that one with a bob long. I noticed that after firing, the longer I let the gun sit (matter o seconds), the higher the gauge pressure would read. I now assume they are getting over pressurized. I assume this is my ASA causing this. If I'm right, how do I fix this. Thoughts? Thank you.
 

·
Retired, proud dad
Joined
·
702 Posts
The reg is not working correctly. Be sure to lube it, a few drops of oil in the ASA should fix your problem.
 
1 - 3 of 3 Posts
Top