Paintball Guns and Gear forums banner

1 - 4 of 4 Posts
A

·
Guest
Joined
·
0 Posts
Discussion Starter #1
I was trying to adjust trigger for empire axe and I fixed it so that it had a good trigger pull but then we turned the marker on it wouldn't fire but it would click. I realized this was because the micro switch set screw was too high up. I moved it down and then it wouldn't click at all. I tried to adjust I back up again and when I was putting the body back on the trigger frame it started blinking red and then I turned it off. It won't turn back on. How do I fix this. Thanks
 

·
Administrator
Joined
·
23,657 Posts
The axe uses contacts to connect the board and the solenoid, yes? I'd start by making sure that the body and frame have been properly put back together, and that the contacts are touching correctly.


This guy suggests that one of your microswitch set screws is sticking out too far.
 
A

·
Guest
Joined
·
0 Posts
Discussion Starter #3
I now realize what happened is that the prongs on the board are bent. How would I fix/replace this cheaply?
 
1 - 4 of 4 Posts
Top