Joined
·
2 Posts
Hi
I was going through the motions of connecting and disconnecting a polar star micro regulator off a U68 gladiatair tank and noticed the top part of the regulator was a bit loose. I tightened the single 2.5mm as this stopped looseness (yes I should have tightened the two smaller set screws), then I noticed the pressure gauge gone very negative.
I suspect I might-have damaged the gauge.
I did notice a release of air when adjusting the +/- gauge. Is it possible that somehow I wrecked the gauge?
could I have wrchecked anything else?
I was going through the motions of connecting and disconnecting a polar star micro regulator off a U68 gladiatair tank and noticed the top part of the regulator was a bit loose. I tightened the single 2.5mm as this stopped looseness (yes I should have tightened the two smaller set screws), then I noticed the pressure gauge gone very negative.
I suspect I might-have damaged the gauge.
I did notice a release of air when adjusting the +/- gauge. Is it possible that somehow I wrecked the gauge?
could I have wrchecked anything else?
