Paintball Guns and Gear forums banner

1 - 8 of 8 Posts

·
Bill Daimler
Joined
·
166 Posts
Discussion Starter #1
my mini is leaking out of the asa,
also the asa is sliding back and forth, thats prolly related to the problem

any help would be greatly appreciated
 

·
Bill Daimler
Joined
·
166 Posts
Discussion Starter #3
thanks, i tried that before i made this thread tho, it did make the leak a little less
 

·
Registered
Joined
·
6,346 Posts
There is a powertube inside the grips, make sure the power tube is screwed into the asa as much as possible. Grease the O-ring inside the powertube, tighten up the screws to the asa, grease the O-ring in the inside of the gripframe for the ASA. This one is a long shot but check your tanks O-ring.
 

·
Bill Daimler
Joined
·
166 Posts
Discussion Starter #5
tried all that, i wouldnt make a thread without trying the simple stuff
 

·
Administrator
Joined
·
14,020 Posts
tried all that, i wouldnt make a thread without trying the simple stuff
you would be supprised at the amout of people that dont try these things before posting

my marker wont shoot

is your tank filled?

well no but.....

(this is the area that i was going to post my suggestion because i had a similar problem with an asa a while back but i just forgot what i did to solve it)

o there it is, so you may want to try wrapping your tank treads with some plumbers tape just to see if thats where the leak is occuring, if it seals it up you know its a problem with the asa and tank seal, if not it may be a problem with the asa sealing to the reg.
 

·
Bill Daimler
Joined
·
166 Posts
Discussion Starter #7
ok thanks, ill try it at practice tmmrw night
 

·
Registered
Joined
·
6,346 Posts
If your asa is sliding back and forth it has to be a problem with the attachment screws.
 
1 - 8 of 8 Posts
Top