[StingRaysSuck]

All right this is the third time ive had to deal with leaking on this *****. so yes to the problem i put my co2 on and **** is leaking through the barrel and around the pin where the valve is it comes out of there. and damn it i replaced all the o rings on every spot and this **** is difficult. i dont know if i have the valve on right though. but yes any help on this **** will be greatly appreciated. god damn shutter.

 

[Stan]

try replacing your cupseal, that is most likely your problem, it could be scratched or damaged, it may not looked damaged, but it most likely is

 

[Mooney]

i would have to go with monkey on this one. Check that, and if thats not it i would take it to your nearest pro shop and see what they have to say about it.

 

[StingRaysSuck]

its been used like 4 times. about to take it to the nearest trash can. lol

 

[Stan]

im guessing you might also have valve damage, maybe when past owners were messing around they scratched the valve

 

[sick_dawg]

No, it sounds just like a cup seal. Very simple to replace, and they normally last quite a while, but basically go out whenever they feel like it. I doubt that he has any valve damage tho. Replacing the cup seal should fix it right up.

 

[StingRaysSuck]

I got it brand new

 

[Stan]

but did u change the cupseal yet? I am 99% positive itsteh cupseal, you should have gotten an extra cupseal with your gun, so just replace it, and you wont need to throw your gun out