Paintball Guns and Gear forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
568 Posts
Discussion Starter #1
I want to take my CVX apart. Clean, lube and reassemble. Getting bad velocity spike drops. Tippmanns website does not have a document for doing this. Please point me in the right direction. How does it come apart. How do you reassemble? How does it work?

Thanks!
 

·
Registered
Joined
·
568 Posts
Discussion Starter #2
I'll give you my own way

Since I couldn't find squat..what you do is put the thing over a hole in something. I used my teflon tape dispenser. Use a plastic pen with the tip retracted to push the plunger in. Put a zip tie in the hole on the side to hold it back. Use a large jewelers screw driver to work the lock ring out. Be careful to not scar the inside surface. Take apart. Lube, Inspect and reassemble. Not very hard and not much to go wrong either. I think it was fine.
 

·
Registered
Joined
·
62 Posts
i wouldn't bother taking it apart, just put a couple of drops of lube into your asa, dryfire about ten times without the barrel on, and the internals will be completely lubed. taking apart the valve also voids the warrenty on your tippmann.
 
1 - 4 of 4 Posts
Top