Paintball Guns and Gear forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hi, i just registered to these forums to get some help with this, i recently bought a VSC kit off Wevo and found that it was a pain in the ass to install. I attached it to my gun and when i put in my gas source i found that it leaked from pretty much everything i had to tighten. Upon further tightening the hardline attachments didnt leak, but the right angle bolt that attaches the hardline to the gas source still leaked. I have tightened it sufficiently and it still leaks and i fear that further tightening will strip or ruin the part. Is it natural for them to have to be tightened so much? I'd appreciate help from any experienced phantom owners on this forum. Thanks.
 
1 - 2 of 2 Posts
Top