Paintball Guns and Gear forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
So every other time I fire, it seems the CO2 doesn't fire with the gun. As in I'll fire once, it will work just fine. However I will fire again, and the gun will fire as if it doesn't have CO2 attached. And then I have to cock it again, and it will fire good for another shot. Advice appreciated!
 

·
Registered
Joined
·
1 Posts
98 problem

open your marker you may have junk keeping you rear bolt from recocking, if it is a old marker tis happens you may also have a bad or worn out spring getting bound up with the guide pin, maybe bad o-ring letting to much air by for it to blowback to catch sear. good luck
 
1 - 4 of 4 Posts
Top