Paintball Guns and Gear forums banner

1 - 5 of 5 Posts

·
\/ My First avitar \/
Joined
·
1,673 Posts
Discussion Starter #1
What should I do to keep it in working order. I have no clue how to open it so some help would be good.

What are some general oldschool gideline?
 
D

·
Guest
Joined
·
0 Posts
contact nick.. his screen name on pbf is BUBBASR, he owns one, if hes not busy pimping he'll probably help ya
 

·
Registered
Joined
·
53 Posts
I own a lot of nightmares. 4 to be exact. Just clean them once in a while. To take apart its very simple. Leave the whole upper half of the gun alone (puncture pin...). Next take off pump arm (unscrew screws that go into the bolt and hammer). Next take off the frame. Then unscrew set screws that hold in valve. Next pop out the back piece and everything should slide out of the gun. You may have to tap the valve with an allen wrench or something to get it out. Run squeegee through the gun. Wipe parts clean. Do not disassemble the valve. Just wipe it off. Reoil everything and put back together. Make sure to oil the pump arm.

These guns shoot a lot better if you polish the internals. To do this, rub with neverdull and if ruff surface, sand with croakus cloth and oil. Then rub with neverdull. If surface is rusty, make sure all seals are removed and soak part in CLR, wipe clean, oil, rub with croakus cloth till surface is smooth, wipe clean, rub with neverdull till shiny and polished. Then wipe with clean cloth. Make sure to rub inside of all holes (set screw and screw holes) with neverdull and wipe clean with paper towel. Soak screws in CLR and wipe with neverdull to remove rust and grime. Then let parts sit for a night. Then oil all parts, oil o-rings, and put back together.
 
1 - 5 of 5 Posts
Top