Paintball Guns and Gear forums banner

1 - 12 of 12 Posts

·
Registered
Joined
·
11,482 Posts
when we say "sand the feedneck" we are talking about sanding the part of a hopper that goes in the feedneck. This is so if the fit is tight it goes in better.

and u HAVE to use sandpaper.
 

·
Registered
Joined
·
815 Posts
You might want to go to a proshop and have someone there do it for you because you might screw up your hopper.What hopper do you have?
 

·
Registered
Joined
·
20 Posts
Discussion Starter #10
yeah i think i'm going to do that, ima buy a new feedneck probly. and i have a 12v revvy w/xboard.
 

·
Liquor for da Homiez
Joined
·
5,338 Posts
The Revvy's already have a brittle shell that is notorious for breaking... Get a clamping feedneck, followed by a new hopper. :tup
 
1 - 12 of 12 Posts
Top