Paintball Guns and Gear forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
OK I just got a new marker and PMI (pure enegry) remote and I'm having trouble getting the air flow to cut off but unscrewing the knob at the top of the tank. It should be noted that I'm using a Crossman pre-charged CO2 tank with a paintball adapter for testing (my real CO2 tank is empty.) Has anyone had this issue? I'm thinking that the pin on the adapter is too long or not inset like a standard Co2 tank so that it's not closing off when I unscrew the knob. Is there a standard spacing for the pin length and the indention where it lives? The remote does lot allow for removing the knob or unscrewing any farther, which seems like a good thing.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #2
Hrmm This morning I fired the remainder of the air out of the prefilled 88gram (3.1 oz) tank and looked at the adapter for it and it does seem like it has a less shallow indentation than a standard CO2 tank. Hopefully the real CO2 can be shut off by the PMI remote.:shrug: I'll post once I'm able to charge it up at the field.
 
1 - 2 of 2 Posts
Top