Paintball Guns and Gear forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
Help! My victor isnt working properly, I went to use ut on sunday and when i put on my co2 and fired a few practice shots it started to motorboat, so i put on a full tank and it gave me 3 shots before it motorboated, i recocked it and fired off a couple and it did the same thing, i have no clue what is wrong someone please tell me how to fix it i dont want to lose her!
Thanks =(
 

·
Registered
Joined
·
208 Posts
First check your o-rings. If all are properly oiled and not torn, then check your striker and sear for wear.
 

·
\/ My First avitar \/
Joined
·
1,673 Posts
Ya you have a bad seal it souds like. Put a few drops of PAINTBALL OIL on the 2 o rings on the bolt, and some drops on the hammer red o ring. The put about 3 drops in the ASA and dry fire about 20 times. Should lube everything up for you good!
 

·
Registered
Joined
·
140 Posts
It's mostly likely an oring somewhere that's torn. Check all the orings in your marker. Did you touch the valve? like for cleaning or anything?
 
1 - 5 of 5 Posts
Top