Paintball Guns and Gear forums banner

problem with trigger frame

691 views 11 replies 8 participants last post by  Kirkysboy 
#1 ·
i took it off to sand and polish the sear, and now when im playing it keeps wanting to get loose, so i have to keep tightening the screws, its very annoying. any way i can make the screws stay in place
 
#2 ·
try using some plumbers tape
 
#12 ·
Teflon tape and/or Blue Loctite should be in your tool box at all times. And Otter just says to lightly sand the top part of the sear (not enough to take wear it away or round it off). You need to sand a little to smooth it out to work in the polish, it wont harm it if you do it right. If you do it to much your going to have recocking issues with the sear and stricker timing along with dwell problems.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top