Paintball Guns and Gear forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
504 Posts
Discussion Starter #1
Hye I am having problems from my DM4 on/off and i was thinking its the o-rings because they look about level in the grove and it slides out pretty easy. Im try that but any suggestions please let me know thankx.
 

·
Registered
Joined
·
28 Posts
The top oring is being cut when putting it in the gun use some slick honey and slowly rotate it and make sure you check it once its in by slowly turning it and looking at the oring on the top around the air inlet hole. Just take you time and lube it up really well and that should take care of that.
 

·
Registered
Joined
·
337 Posts
^^ bunkertime is correct check for barbs because it shouldnt do that if there are barbs then buff them!!
 
1 - 9 of 9 Posts
Top