Paintball Guns and Gear forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
whats everybody? i got a question i am just starting to get back into paintball agian after about 5 years or so. i got an old 98 (no custom like when they first came out) and a procarbine. i was wondering if i buy all these new parts they have will they fit on my markers? or would i have to get a new 98 custom? and if so what parts can i add to the procarbine? thanks.
 

·
Registered
Joined
·
42 Posts
Pro/Carbine: This (15 days left):
32 degrees Spyder Vertical adapter - eBay (item 200334041403 end time Jun-19-09 19:09:41 PDT)
will screw right in where the steel hose screws into the receiver, and you can put an expansion chamber on that. That's what I did.
You can also polish the internals, I only did the rear bolt because I couldn't figure out how to remove the powertube (didn't put much effort into it). It will seem like it's already quite smooth, but trust me, you will notice a difference.
Put a new barrel on every marker.
Dye sticky grip. No changes performance-wise but have you felt one of these!?

That's what I've done to my P/C. I'm not going to pretend to be an expert on the gun, but hopefully that helps at least a little.
 
1 - 2 of 2 Posts
Top