Paintball Guns and Gear forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Looking for a bottom line feed for co2 tank. Are these pretty much standard? Could I buy one made for a Spyder? Can't seem to find any cheap ones on ebay for raptor.
 
2

·
Guest
Joined
·
0 Posts
Easy as cake, but you won't find them as a kit, you need to buy individual parts. And by buying a spyder one you run the risk that spyder parts don't have the same threading as everything else in paintball.

Take off the braided line from the vertical ASA, an you will probably find that the ASA is threaded for a tank. There you can install a standard expansion chamber or a regulator. Then get yourself some shorter braided line and connect your expansion chamber or regulator to your asa. It's all screwing things on and off, no biggie.
 

·
Registered
Joined
·
69 Posts
instead of using a reg, id go for just an expansion chamber since your using co2. this might save you $20-$30 depending on the one you get. and for asa i recommend a trinity asa
 
1 - 3 of 3 Posts
Top