Paintball Guns and Gear forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
232 Posts
Discussion Starter #1
I just go my egg a few weeks ago and have played with it twice. Now both days I played it was pretty damn hot out, but I noticed that lots of times my egg would just stop feeding and I would have to turn it off then on.

This has happened to me several times a game at points and im dont think that its entirely due to paint getting stuck in the feed tube.

Also I plan on getting an X-Board soon anyway, but does it have some type of feature that might help me with this?
 

·
Registered
Joined
·
232 Posts
Discussion Starter #3
i'll check. but i dont think they are, everytime I do a drop test every ball goes through perfectly
 

·
Registered
Joined
·
3,172 Posts
Crank the feed rate all the way up. Makesure the batteries are good and that your battery door is shut tightly. I had this problem until I modded my board to use battery clips instead of pressure contacts. All 9 volt batteries are not exactly the same size. So some batteries dont make as good of a contact on the pressure contacts and the problem get really bad if the battery door is cracked.
 
1 - 4 of 4 Posts
Top