Paintball Guns and Gear forums banner

1 - 2 of 2 Posts

·
Wishes to play Pball moar
Joined
·
493 Posts
Discussion Starter #1
Okay, here's the deal. I went to go clean the inside of my Diablo Wrath a while back and when I went to screw the LP hose fitting from the ram housing, the screw twisted and snapped in half for some reason! So now I'm ordering a new LP hose fitting, but I can't figure out for the life of me how to take the LP fitting off of the hose without breaking something. How would I go about doing this? Here are some pictures:
 

Attachments

·
Registered
Joined
·
1 Posts
Look at the fitting. The small ring will slide in and that releases the LP hose. When you re-insert the hose, just check that the ring slides out again. It is like a plastic quick connect.
 
1 - 2 of 2 Posts
Top