Paintball Guns and Gear forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
2,228 Posts
Barber said:
I got myself one of those new Speedfeeds a couple days ago. So, I decided to do a little review on it.

The Speedfeed was $18.95 plus shipping from the manufacturer. Total it was $24.90 and it got to me in 2 days. Not bad.

As soon as I got the Speedfeed, I installed it onto one of my Halos. Since the Halo didn't have a lid on it, installation was simple, and took me 3 seconds or so. If you are putting the Speedfeed onto a Halo with a lid installed, installation will take a little longer, but it is still easy. Simply split your Halo halves, remove the lid/pin/spring, and put the halves back together. The the Speedfeed snaps onto the collar of your Halo.

To remove the Speedfeed, simply lift up on the little tab on the back side of it. It's a little hard to get off if you have big hands, like myself, so I just wedged a screwdriver under it and lifted. Simple.

When I was finally able to put some paint through it, I noticed that the fingers were a little stiff. So after I put the paint back into the pod I had it in, I just used my fingers to play around with the Speedfeed's fingers to loosen them up a little.

After messing with them for a bit, I started putting more paint through it. After about 8 more pods, the fingers seemed really loose and the paint just went straight threw it.

If you are worried about paint coming out of the Speedfeed, don't be. I turned my Halo upside down and shook it for a good minute or so, and only lost 1 ball.

The Speedfeed is a great product for the price. It cuts down your reloading time by a few seconds, and makes it easier to reload and shoot. Installation is simple. If you have the cash, pick one up.

Speedfeeds fit Halo, Reloader Bs, Suicide Halos, Revvys, and Ricos.
Barber made this obviously.
 

·
Registered
Joined
·
2,228 Posts
um yeah that would pretty much suck. rain rolls right in through the top and into the internals. not cool.
 

·
Registered
Joined
·
516 Posts
Gangsta_Redneck- Did you have to sand off the lip of your halo lid to get your ghetto speed feed on? I'm thinking of trying one, but I've heard you have to sand it so it will fit on the halo.
 
1 - 9 of 9 Posts
Top