Paintball Guns and Gear forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1 (Edited)
Sorry if this has been asked before, but this is my first time on the forum :p. I have an old Spyder 2000 (hardly used) that I just started using again. After about an hour of use, CO2 started venting from the regulator adjust screw. Tightening doesn't seem to make much difference. Is there any way I can fix it? Do I have to replace the entire ASA? Are there still ones available that will work with this model? Thanks in advance for your help.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #6 (Edited)
Regarding if the tank was on right, the leak was occurring at the screw next to the gauge. The tank was on all the way and it was sealed correctly. I removed the tank and re-attached with the same result. Thanks for the question.

Regarding huckduck Super Moderator, I will give your suggestion a try. Thanks.
 
1 - 6 of 6 Posts
Top