Paintball Guns and Gear forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I’m looking for two spyder fenix boards. Either tadao with the upgrade chip or a virtue board. Don’t bother telling me to buy something else. It’s for a project a little bit of fun seeing what all i can do to make these things fun shooters. Already upgraded the reg, asa and barrel. Now I need to do the feedneck and upgrade board but I can’t find any boards.
 

·
Administrator
Joined
·
14,107 Posts
Yeah nobody makes them really. Is this the older or newer Fenix?

Sure players can upgrade them but the stock boards cone with pretty much everything about 90% of the players want. So nobody makes a board to just cater to the last 10%

If you want to do something cool, back block it. All that's needed is a few tools, elbow grease and patience on your part

Sent from my Moto Z (2) using Tapatalk
 

·
Administrator
Joined
·
14,107 Posts
Not really. All you are doing is chopping off the back side of the top tube.

Below is one that I did. If you locate the valve in the lower tube and go about a half inch back from there, everything behind that point in the UPPER tube is not needed. You can hack it off or do whatever you want with that metal but you can take a lot of weight off of a sitter doing this

Just be sure not to remove the pin hole that holds your back block in place




Sent from my Moto Z (2) using Tapatalk
 
1 - 4 of 4 Posts
Top