Paintball Guns and Gear forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
1,852 Posts
Discussion Starter #1
My freind installed the Tboard and it was workin fine, but then he installed his 50gram switch, and the little clynder-thing, at the top of the Trigger frame, wont activate the sear trigger, so the trigger is on, but it doenst shoot. I told him to read the directions, but hes a dumbass.
 

·
Registered
Joined
·
1,307 Posts
yea, the cylinder thing is the selenoid, check all the wires
 

·
Registered
Joined
·
2,798 Posts
There are three things to check:
- That the two set-screws holding down the solenoid are firmly tightened; otherwise, the solenoid will move when when activated (but not the sear)
- That he didn't accidentally mix up the solenoid and battery wiring harnesses (pretty easy to plug them in the wrong sockets)
- Make sure that the dwell is high enough! I usually start at 8ms, then go down from there when tuning other's Spyders (with T-boards, that is)
 

·
Registered
Joined
·
292 Posts
I dont mean to hijack but while we're on the subject. If you already ahve a 50g switch installed can you just install the board?
 
1 - 8 of 8 Posts
Top